VapeWholesaleHub  |  Wholesale supplier · Shenzhen, China
Tel / WeChat / WhatsApp: +86 13711127975  |  vape@0099933.xyz
Home  /  Vape Juice  /  Vape Juice label proof — pre-order guide
vape juices · convenience store chains

Vape Juice label proof — pre-order guide

A vape juice programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.

Published 17 February 2025  ·  VapeWholesaleHub  ·  Reading time 8 min

Carton-ready units from the same batch, coded for traceability.
Carton-ready units from the same batch, coded for traceability.
Close inspection of the assembly line before the batch is released.
Close inspection of the assembly line before the batch is released.

Sell-through notes for the shop floor

We work with convenience store chains who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.

Shelf position decides velocity as much as price. Keep vape juices at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.

Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.

What a sensible opening order looks like

Colour range is where assortments quietly die. Six finishes look impressive in a brochure and disastrous on a shelf with 40 cm of space. We recommend two finishes per core SKU and let the trial line carry the novelty.

A practical starting order for convenience store chains is 500 units across two or three SKUs, not 500 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.

For convenience store chains, the practical answer is usually a shorter range: two core lines, one step-up, one trial SKU. Everything else is inventory risk wearing a nice finish.

What we test before a carton is sealed

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Every batch is pulled from running production, not from a display shelf. We check draw resistance, airflow balance, charge behaviour, leak performance after a temperature shift, finish quality and carton integrity, and we keep the pull records against the order number.

  • Batch codes traceable from carton back to production date
  • Document pack prepared per destination market
  • Consolidated or split shipping, quoted both ways
  • Cartons drop-tested and pallet-counted for clean freight
  • Artwork proof plus physical dummy for custom packaging
  • Specification locked in writing before production starts

Compliance without the last-minute scramble

Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.

We keep batch codes traceable from carton to production date. When a market authority asks for traceability, a supplier who cannot produce it in an hour becomes a liability very quickly.

Specification summary

Typical specification for this category
Volume50 ml
Strength3 mg
Base ratio50/50 PG-VG
Flavour range48 profiles
ClosureChild resistant
BottlePET
Minimum order50 units per SKU, mixed cartons allowed
Lead time30 working days after artwork approval

If any of this is unclear, the fastest route is a message rather than a meeting. Send the market you sell into and the price band you work in, and you will get a specific answer instead of a brochure.

Frequently asked

Can you ship to multiple locations?

Yes. Split shipments are quoted separately because consolidation and splitting price differently. Tell us the destination list at quotation stage and we will show both options.

What happens if part of the order is defective?

Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.

Can we order samples before committing?

Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.

Related reading

Need a quotation on vape juices?

Send destination market, target price and quantity. Same-day reply on working days.

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz

Talk to the supply team

Ask for a quotation on vape juices

Tell us the market you sell into and the price band you work in. You will get a specification and a landed cost estimate, not a catalogue dump.

What to send

Destination market, target retail price, quantity per SKU, and whether you need private label. With those four lines we can quote the same day.

Samples ship by air express and the cost is credited against your first production order.

Email the team
WhatsApp Email us